| |
PAGE 3 |
TO ORDER CALL 310.535.7003 |
|
|
|
|
IMPORTANT SAFEGUARDS Cont. |
|
|
1. It is important to avoid the possibility of an electrical aquarium accessory or receptacle from getting wet. Position the aquarium stand and tank to one side of a wall mounted receptacle to prevent water from dripping onto the receptacle or accessory plugs. A “drip loop”, shown in diagram 1 on page 13, should be arranged by the user for each power cord connecting an aquarium appliance to a receptacle. The “drip loop” is that part of the cord below the level of the receptacle (or connector if an extension cord is used) to prevent water from traveling along the cord and coming in contact with the receptacle.
DANGER – If the plug or receptacle does get wet, DON’T unplug the cord. Disconnect the fuse or circuit breaker that supplies power to the appliance. Then unplug and examine for presence of water in the receptacle.
2. Unplug any accessory when not in use, before installing or removing parts, and cleaning.
3. Do not use any aquarium accessory for other than the intended use.
4. Do not install or store the SCWD or other accessories where they will be exposed to the weather or temperature extremes.
5. Make certain the device (SCWD) is securely installed and all fittings are tight before operation. If using the 1” model, also make sure the cap is secure and tight.
|
|
|
|
|
|
| |
PAGE 4 |
|
|
|
|
|
SCWD WaveMaker
INSTRUCTIONS |
|
|
Manufactured to the highest standards of quality and reliability, your new 3iQ Ventures LLC SCWD WaveMaker is designed to provide convenient, trouble-free operation. Careful attention to these instructions is the first step in ensuring that your WaveMaker will perform as intended.
PLEASE Read All Instructions Completely Before Attempting to Install and Operate Your SCWD WaveMaker, Paying Close Attention Specific Instructions for the 3/4 Inch and 1 Inch Models.
Special Note: Although there are many different ways to install your new SCWD, the following instructions reflect the most common method of installation. In addition, even though your new SCWD is not overly sensitive to the normal particulate and debris found in aquarium systems, to ensure long life, it is strongly recommended that water be filtered prior to entering the SCWD.
(1 “ Model Only)
Your new SCWD has come preassembled with the standard drive assembly installed. For installations that require switching speed adjustments, an additional drive assembly and carrier package may be purchased separately.
Instructions for removal and installation of drive assemblies and carriers, or cleaning your SCWD are provided in the Maintenance section of this manual.
|
|
|
|
|
